Attaching/Removing the Stand

Attaching an Optional Monitor Arm

An optional arm (or optional stand) can be attached by removing the stand section. Please refer to our web site for optional arms (or optional stands) that are supported.

When attaching an arm or stand, the installable orientations and movement range (tilt angle) are as follows:

Attention

  • When attaching an arm or stand, follow the instructions of the respective User’s Manual.
  • When using an arm or stand by another manufacturer, confirm the following points in advance and select one that conforms to the VESA standard:
  • Clearance between screw holes: 100 mm x 100 mm
  • Plate thickness: 2.6 mm
  • Strong enough to support weight of the monitor unit (excluding the stand) and attachments such as cables
  • Connect the cables after attaching an arm or stand.
  • Do not move the removed stand up and down. Doing so may result in injury or device damage.
  • The monitor, arm, and stand are heavy. Dropping them may result in injury or equipment damage.
  • Check periodically that the screws are tight enough. If the screws are not tight enough, the monitor may come unattached. This may be the cause of injury or damage.
  1. Lay the LCD monitor on a soft cloth spread over a stable and flat surface with the LCD panel surface facing down.
  2. Remove the stand.
  3. Prepare a screwdriver.
  4. Use the screwdriver to remove the screws that secure the unit to the stand.
  5. Attach the arm or stand to the monitor.
  6. For installation, use commercially available screws that meet the following conditions:
  7. Nominal diameter: M4
  8. Length: Between 9.4 mm and 12.0 mm (if using washers, add the washer thickness)